Welcome to Firefly
English
Firefly Docsss
Last Updated: 2026-11-18 14:24:01

Display Usage

Introduction

Firefly-R3572A supports two types of display output:

InterfaceConnectorSpecification
HD2.1Standard HD connectorUp to 4K@60Hz
MIPI DSIJ18, 30Pin-0.5mmDPHY 1.2, 1×4 Lanes, 2.5 Gbps/Lane

The system supports dual-screen independent display output of 4K@60fps + 2K@60fps.

HD Display

The HD interface supports hot-plug detection. After connecting a display, the system completes the resolution negotiation automatically. Check the current display mode:

cat /sys/class/drm/card0-HDMI-A-1/status
cat /sys/class/drm/card0-HDMI-A-1/modes

The device node name depends on the system. Check with ls /sys/class/drm/.

MIPI DSI Display

The DSI interface (J18) of Firefly-R3572A supports 4-Lane data output. The DSI is referred to as dsi in software, and the default connected panel is the Firefly V2 display. The board-level configuration of this panel is located in the SDK at kernel-6.12/arch/arm64/boot/dts/rockchip/rk3572-firefly-r3572a-mipi101-BSD1218-A101KL68.dtsi, enabled/disabled by the DSI switch in the main dts.

The main parameters of this panel are as follows (refer to the SDK dtsi):

ItemParameter
Resolution800 x 1280
DSI Lane4 Lane
Pixel clock70 MHz
Compatiblesimple-panel-dsi
Touch panelGoodix GT9xxx capacitive touch on I2C6

Besides the 4-Lane video signals, the DSI connector (J18) carries the touch panel I2C (I2C6), backlight control (LCD_BL_EN, LCD_BL_PWM) and reset signals.

  • J18 DSI interface

  • V2 display timing

  • V2 display power-on timing

To bring up the MIPI panel, complete the following configurations:

  1. Configure the panel power, reset, backlight and DSI timing parameters in the board-level DTS (the dtsi above) and include it.
  2. Confirm that the touch panel I2C address is on I2C6.
  3. After building and flashing the firmware, verify the display output with modetest or the desktop environment.

Note

The LCD control signals on J18 are at 3.3 V. Confirm the level matching before connecting a panel or an adapter board. When using a different panel, configure the corresponding DTS according to its timing.

Dual-Screen Independent Display

The system supports independent display output on HD + MIPI DSI. In a desktop environment, configure the display mode of each screen in the display settings; in a command-line environment, use modetest or the output configuration of a compositor (such as weston).

The maximum resolution and frame rate of each interface depend on the SDK firmware.

Debug Methods

  • Get the EDID of the HD output
busybox hexdump /sys/class/drm/card0-HDMI-A-1/edid
  • Get the resolutions supported by the HD output
cat /sys/class/drm/card0-HDMI-A-1/modes
  • Get the connection status of the HD output
cat /sys/class/drm/card0-HDMI-A-1/status
  • Get the information of the Video Port currently in use (and the connected display controller)
cat /d/dri/0/summary

Generally, when the HD/MIPI DSI display does not work, run the commands above first to check whether the connection status, EDID and resolutions are correct.

On this page