Hardware Function Usage

Debug Serial Port

The EC-A3399ProC computer does not expose a debug serial port. You need to open the enclosure to access the debug serial port (Debug) on the AIO-3399ProC motherboard, and connect a USB to TTL serial adapter for debugging. The serial port parameters are: baud rate 1500000, 8 data bits, 1 stop bit, no parity, no flow control.

For the connection and usage of the debug serial port, please refer to: Debug Serial Port.

Display Interfaces

The AIO-3399ProC provides 1 HDMI 2.0 display output interface, supporting up to 4K@60Hz output with HDCP 1.4/2.2. In addition, the motherboard supports MIPI-DSI/eDP display outputs (available after opening the enclosure), and mirrored or extended dual-display configurations are supported.

Ethernet

The AIO-3399ProC provides 1 RJ45 Gigabit Ethernet port, which is recognized as the eth0 device in the system.

After the Ethernet port is connected to the network, you can check the IP address via the debug serial port or adb:

ifconfig eth0

Connectivity test:

ping -I eth0 -c 10 www.baidu.com

USB Interfaces

The AIO-3399ProC provides the following USB interfaces:

• 1 x USB3.0 (rear panel)
• 2 x USB2.0 (dual-stacked USB recepts on the front panel), for USB devices such as mice and keyboards
• 1 x Type-C (OTG), mainly used to connect to a host computer for firmware flashing

Serial Ports (RS232 / RS485)

The front panel of the AIO-3399ProC provides 1 RS232 interface (DB9) and 1 RS485 interface (terminal block), which are commonly used to connect industrial equipment:

• RS232: connect RXD, TXD and GND according to the silkscreen of the DB9 connector.
• RS485: when wiring, connect A to A and B to B. If communication fails, check whether the A/B wires are loose or reversed. Note that RS485 shares the same connector with CAN; select it according to the actual configuration.

For a simple test, you can short-circuit the transmit and receive pins of RS232 (short-circuit A and B for RS485), then run cat/echo on the corresponding serial device node in the system to send and receive data (the device node name depends on the actual system).

TF Card

The rear panel of the AIO-3399ProC provides 1 TF card slot for storage expansion. Please power off the device before inserting or removing the TF card.

SIM Card

The SIM card slot of the AIO-3399ProC is used together with a Mini PCIe 3G/4G module to provide mobile network connectivity. The 3G/4G module is optional, and the SIM card function is available only after the module has been installed inside the chassis. The SIM card insertion direction is shown in the figure below. Please power off the device before inserting or removing the SIM card.

Audio

The front panel of the AIO-3399ProC provides a 3.5mm Phone jack for audio output; the HDMI 2.0 interface outputs audio as well.

IR

The front panel of the AIO-3399ProC has a built-in IR receiver and supports the IR remote control function.