Quick Start
Power On
The image below shows the power connector of AIBOX-K3. Connect the power adapter to this connector (use the power adapter bundled with the product):
Cannot power on?
AIBOX-K3 boots up as soon as it is connected to power. During boot, the following logo is displayed:
Note
System Login
The image below shows the Linux desktop of a K3-platform product as an example:
Account and Password
| Platform | Account | Password |
|---|---|---|
| Rockchip | firefly | firefly |
| Sophgo | linaro | linaro |
| Qualcomm | firefly | firefly |
| NVIDIA | nvidia | nvidia |
| SpacemiT | firefly | firefly |
root passwords are not set by default on these firmwares: run sudo passwd root after login to set one. If a firmware has set a root password, it is the same as the normal user password of that platform.
Log in to the System via Any of the Following Methods
- HDMI monitor + mouse and keyboard: log in to the desktop and open a terminal for development
- Debug serial port: available on all products, log in to the command line directly
- ADB: available on some products (mostly via the Type-C port); see the product specification
- For the exact locations of these debug interfaces, see the debug / adb chapters under "Hardware Usage" in the product documentation
SSH Remote Login (Optional): SSH is a common way to log in over the network. The device uses a dynamic IP by default, so first log in via one of the methods above, configure a static IP for the device, and then connect with SSH:
ssh firefly@<device static IP>Getting Started with Application Development
For an introduction to Linux application development, see the community documentation Ubuntu/Debian Development Guide.
Do not run a full system upgrade
sudo apt-get upgrade, sudo apt full-upgrade, or sudo do-release-upgrade. These are embedded products with highly customized kernels and operating systems; running upgrade is very likely to break system dependencies and cause system malfunctions.Note
The image below shows the Android 12 desktop of a 3588-series product as an example. For other platforms, refer to your actual display:
Basic Operation
Right-click works as the Back key
Terminal Debugging
Most Android products support ADB, which allows terminal debugging; the debug serial port can also be used to log in
Debug Interface Locations
See the debug / adb chapters under "Hardware Usage" in the product documentation
Android System Customization and FireflyAPI Development
The following applies to Rockchip products only:
Application Development Collection
Application Software Development Collection
The application software development collection is shown below; click the link underneath to open it:
AI Development Collection
The AI development collection is shown below:
Special note: LlamaPi
System and BSP Development
For system and BSP development (source code, building, firmware flashing), see the development guide chapters in the product Wiki (under "Software Development").

